You are not connected. Please login or register

Phason Support Forum » Frequently asked questions (FAQs) » Multi-stage controls » SEC-HD: 'A EE' or 'A IE' error code

SEC-HD: 'A EE' or 'A IE' error code

View previous topic View next topic Go down  Message [Page 1 of 1]

1 SEC-HD: 'A EE' or 'A IE' error code on 2013-03-22, 4:42 pm

Problem Description
An A EE or A IE error code on an SEC-HD indicates that an internal error has occurred. This can be caused by power fluctuations and electrical interference from other electrical equipment.

Solutions
Adjust and store a parameter. Next, turn the power off and on to clear the alarm.

If that doesn't clear the alarm, reset the factory defaults by holding down the PROG and STORE buttons for 5 seconds as you turn the power on. This will erase all settings so be sure you know them so you can enter them back in.

If the recommendations above don't clear the alarm then the memory is
damaged. Replace the faceplate with replacement kit K310055.

View user profile http://www.phason.ca

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum